The Zody chair balances superior lower back support with a timeless, inspired design. However, when damaged, it loses its ability to provide wellness and comfort. Hence, if the chair is broken, the cost-efficient option is to repair it and buy parts rather than replace it. This article is a guide for fixing a broken Zody chair. It will cover common problem fixes and how to find a repair shop.
Haworth Zody Common Problems and Fixes
How to Fix Haworth Zody Office Chair Armrest
Take a T-20 Torx bit to remove the screw from the original arm pad. Turn your chair upside down to expose the underside of your arm pads. After you’ve turned your chair right side up, remove the old arm pad. Remove the two screws from the arm pad inlay. Once the screws are removed, discard the sliding plates. Take your rectangular conversion plate and line up the holes. Retrieve the original screws you saved and screw the plate into the chair’s armrest with the T-20 Torx bit wrench. Take your screwdriver and screw the plate to attach the new armrests. Your armrests will no longer be able to move laterally but will still be able to turn left and right, forward and backward, and up and down. Turn your chair upright to finish the repair.
Haworth Zody Chair Gas Lift Change
The instructions for properly removing and replacing the gas cylinder are as follows. First, the chair should be on the floor at the beginning. Then a pipe wrench should be placed on the top of the cylinder close to the bottom side of the seat and used to make multiple turns to loosen the cylinder. Then use a mallet to release the cylinder, which can be replaced with the new cylinder. However, make sure to protect your floor when dislodging the gas cylinder.
Haworth Zody Back Tension Dial Repair
Zody’s tension adjustment is a crank located halfway back on the right side of the seat pan. Adjusting the tension control regulates the amount of resistance a user feels when leaning back in the chair and the effort required to recline the chair backward. Forward or clockwise rotation increases the tension, while backward counterclockwise rotation decreases the tension. Zody’s tension can be adjusted to accommodate users of different body types and sizes and other work styles. You can find a replacement online, then disassemble part of the chair to reach the back tension dial so you can unscrew and replace it.
Haworth Zody Equa Gas Cylinder Replacement
To replace the pneumatic cylinder, you will need a lot of tools such as a knockoff punch, torque, and wrench. First, remove the seatback assembly and arms. It is unnecessary to pull the covers to remove the pneumatic cylinder depress the height control lever to raise the chair to the highest position. Next, separate the tilt covers to expose the top of the pneumatic mechanism. Finally, strike the punch with a hammer to knock the end of the cylinder loose from the tilt and remove the pneumatic cylinder from the base and replace it.
How to Find Haworth Zody Chair Local Authorized Repair Shop Near You
Place of Purchase: The best place to check for repair services is the dealer or website where you purchased the chair. They should offer a warranty that may cover the damage. Therefore, contact them. They will provide a repair service close to your current location. You could also make your inquiries with customer service on the Haworth website. » Haworth Zody support
Internet: Use an internet search engine to find a catalog of maintenance specialists that have an online presence. There are also online forums with information on how and where to fix chairs. You can also use the net to find an authorized Haworth dealer near you to assist in the repair.