Most Steelcase Amia costs around $680 or more. Hence, if the chair is broken, the cost-efficient option is to repair it rather than replace it. This article is a guide for fixing a broken Steelcase Amia chair. It will cover common problem fixes and how to find a repair shop.
Steelcase Amia Common Problems and Fixes
How to Remove & Replace Gas Cylinder on Steelcase Amia
Steelcase Amia chairs parts are often easy to remove with the right tools. However, the first step in repairing the gas cylinder is finding a replacement and having the needed tools such as a pipe wrench to make it easier.
The chair should be on the floor at the beginning. Then a pipe wrench should be placed on the top of the cylinder close to the bottom side of the seat and used to make multiple turns to loosen the cylinder. Then a mallet can be used to release the cylinder so it can be replaced with the new cylinder.
How to Remove & Re-Install The Seat Pad on your Steelcase Amia Office Chair
The instructions for how to properly remove the seat pad are as follows. First, you will need a long screwdriver to locate the white quick release tab on the chair’s left-hand side between the plates. Next, lift the quick release tab while lifting the seat slide lever and sliding the seat forward and off.
Finally, align the new seat with the chair control and engage the slots on the bottom of the seat with the tabs located on the seat bearings. Then, slide the eat fully backward while holding up on the seat slide lever.
Removing and Installing the Lumbar on a Steelcase Amia
Lay the chair on its side and peel the j-channel from the back assembly on the back cushion. Then flip the chair over and lift on the back cushion to remove. Finally, remove the lumbar by pulling it out.
To install the new lumbar, place one side of the lumbar into position in the back assembly. Then, flex the lumbar inward and place the other side into position. Place the back cushion onto the chair back and slide the back cushion onto the chair back by starting at the bottom until installed. Lay the chair on its side and install the j-channel.
Steelcase Amia Creaking Noise Fix
Steelcase Amia chairs can be a nuisance when they get squeaky. However, there are easier solutions than getting rid of the chair. One easy fix for creaking noisy Steelcase Amia chairs is to apply silicone spray into the spring system and cylinder under the seat. Make sure to spray both in the front and in the back and also support area for the tension spring. This spray should add some lubrication and thus reduce the noise. Next, test out the chair; if it still creaks, add more lubrication. Alternatively, you can try to tighten the loose screws and bolts and oil them.
How to Find Steelcase Amia Chair Local Authorized Repair Shop Near You
Place of Purchase: The best place to check for repair services is the dealer or the website where you purchased the chair. They should offer a warranty that may cover repair works for any damage. Therefore, contact them. They will provide a repair service close to your current location.
Authorized Dealer near you: In finding a repair shop for your Steelcase Amia, you could consult a nearby chair dealer. Often the dealer would be happy to help since he might win you over as a new customer. You can get the address of a nearby chair repairman, or the dealer can assist with repairs. » Steelcase Amia support
Internet: Use an internet search engine to find a catalog of maintenance specialists that have an online presence. You could also make your inquiries with customer service on the Steelcase website. There are also online forums with information on how and where to fix chairs.